Set SMB Range

There are a few board that tend to lockup when scanning the full Smbus range, for this reason you can limit the range you want to scan.

Edit the MBM 5.ini file and find SMBus Low Scan=$10 and SMBus Low Scan=$7F in the [ADVANCED] section, you can adjust these 2 values to a range you want to try.

• Do not go below $10 or over $7F
• Primary sensor chip normaly sit between $20 and $2F
• Remember that these values are in Hex, so:
  0,1,2,3,4,5,6,7,8,9,A,B,C,D,E,F,
  10,11,12,13,14,15,16,17,18,19,1A,1B,1C,1D,1E,1F...... etc. etc.
• Remember to always put a $ infront of them